Tail Brace Tube and Brackets

Posted on Updated on

While some glue was drying on the elevator I decided to make the tail brace brackets.

These are made from RS-302 and were not too difficult to make.  After a little polishing they look like this.

image

After that I was thinking of the easiest way to drill the holes in the RS-402 brace tubes and keep the bit on center. The brackets made a prefect guide.

image

image

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s