Leading Edge Varnish

Posted on Updated on

After the leading edge stringer was contoured to match the nose ribs I pre-fit the plywood sheeting. While the plywood was installed I marked the centerline of the stringer on each end and from the inside I attempted to mark the stringer and rib locations.

Then the plywood was removed and lines connected and added so I know where the glue areas are so I can avoid putting varnish there. Two coats of varnish were applied to all non glue areas.

image

The spar, ribs and stringer were varnished except where glue will be applied.

image

image

At least two coats need applied, once dry it will be time to glue the plywood on the leading edge.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s